The Print Result Is Not What Was Expected - Fuji Xerox ApeosPort-IV 5070 Administrator's Manual

The Print Result is Not What was Expected

If the print result is not what was expected, identify the symptom in the following table
to perform the remedy.
Symptom
Outputs are not
stapled.
The 2-sided
printing is not
available.
The document is
printed on a
different paper
size than
specified.
The image on the
document edges
is missing on the
output.
The printed font
differs from the
font specified on
the computer.
The printout is
not offset.
Printing is slow.
The specified
print options are
not enabled.
The document
edges are
missing on the
printout.
Black lines are
printed.
Cause
The Finisher is not installed. The Finisher is required to staple. Install
The number of pages to be
stapled exceeds the
maximum number for
stapling.
The print page buffer is
insufficient.
The document size is
different from the paper size
loaded in the specified tray.
The image is larger than the
printable area.
Font replacement is set on
the print driver.
The machine does not offer
the Offset feature.
[High Resolution] is
selected for [Image Quality].
The print driver for another
model is used.
The required optional kit is
not installed on the
machine.
The image is larger than the
printable area.
A print driver for another
machine is used.
Trouble during Printing
Remedy
the Finisher, or change the print option
settings to cancel stapling.
You cannot staple more than 50 pages.
Reduce the number of pages to 50 or
fewer.
Add memory.
Change the size of paper in the tray, or
change the print option to specify a tray
that contains the correct sized paper.
Expand the printable area of the machine,
or reduce the image size on the printout.
Check the font replacement table.
To output offset, the Finisher is required.
When image data, such as photos, is
printed with the high resolution, the print
speed becomes slow. Select [Standard] for
[Image Quality].
Install the print driver for the model.
Check the optional components installed
on the machine, and set [Installable
Options] under [Configuration] in the print
driver again.
Expand the printable area of the machine,
or reduce the image size on the printout.
Install the print driver for your machine.
15
419