Copy Service Settings; Copy Tab - Features Allocation - Fuji Xerox ApeosPort-IV 5070 Administrator's Manual

5 Tools

Copy Service Settings

In [Copy Service Settings], you can configure settings related to the Copy feature. The
following shows the reference section for each procedure.

Copy Tab - Features Allocation ................................................................................................156

Preset Buttons ...........................................................................................................................157
Copy Defaults ...........................................................................................................................157
Copy Control.............................................................................................................................161
Original Size Defaults...............................................................................................................162
Reduce/Enlarge Presets.............................................................................................................163
Annotations - Create Comments ...............................................................................................163
1
On the [Tools] screen, select [Copy Service Settings].
For the method of displaying the [Tools] screen, refer to "System Settings Procedure" (P.108).
2
Select an item to set or change.
Copy Tab - Features Allocation
You can customize the features displayed on the [Copy] screen. Setting the most
5
frequently used features enables you to avoid extra operations such as selecting tabs.
1
Select the number of features displayed on
the [Copy] screen.
4 Features
The following four features are shown on the screen: [Reduce/Enlarge], [Paper Supply], [2
Sided Copying], and [Copy Output]. Features and positions displayed cannot be changed.
7 Features
Allows you to set features appearing in the fourth column from the left of the [Copy] screen.
Note
10 Features
Allows you to set features appearing in the third and fourth columns from the left of the [Copy]
screen.
Note
2
From [Frequently Used Features] on the right of the screen, select a button and the
position of the button where you want to allocate a feature.
Note
3
Select a feature to display, and select [Save].
Note
4
Repeat steps 2 and 3 as required.
5
Select [Save].
156
• [Reduce/Enlarge] and [Paper Supply] cannot be specified.
• [Reduce/Enlarge] and [Paper Supply] cannot be specified.
• The position of each button on the right side corresponds to the position on the [Copy]
screen.
• Select [ ] to display the previous screen or [ ] to display the next screen.