Energy Saver Mode - Fuji Xerox ApeosPort-IV 5070 Administrator's Manual

1 Before Using the Machine

Energy Saver Mode

The machine is equipped with Energy Saver mode that reduces the power
consumption by saving the electricity of the machine when no copy or print data is
received for a specified time.
The Energy Saver has two modes: Low Power mode and Sleep mode.
When you do not use the machine for a specified period of time, the machine enters
Low Power mode.
When time exceeds the time specified in Low Power mode, the machine then enters
Sleep mode.
Press the <Energy Saver> button on the control panel to enter Energy Saver mode.
Low Power Mode
1
Low Power mode reduces the power to the control panel and the fusing unit.
It extinguishes the touch screen and lights up the <Energy Saver> button on the control
panel. To activate the machine, press the <Energy Saver> button. Pressing the
<Energy Saver> button extinguishes the light and deactivates Energy Saver mode.
Sleep Mode
Sleep mode reduces the power to the machine even more than Low Power mode.
It extinguishes the touch screen and lights up the <Energy Saver> button on the control
panel. To activate the machine, press the <Energy Saver> button. Pressing the
<Energy Saver> button extinguishes the light and deactivates Energy Saver mode.
It takes longer time than Low Power mode to deactivate Sleep mode and be enable to
use the machine.
Note
24
• When you press the <Energy Saver> button during Energy Saver mode, the touch screen
lights up. At this point, the scanner and the output devices remain Energy Saver mode.
Afterwards, by operations such as using the touch screen and opening or closing of the
document cover, you can make the devices necessary to activate the machine exit Energy
Saver mode and make the machine ready to start exiting Energy Saver mode.
• When you make the machine exit Energy Saver mode by pressing the <Energy Saver>
button, the machine does not immediately identify the movements such as opening or
closing of the front cover. To make the machine identify these operations, operate the
control panel before opening the front cover.
• If you replace a toner cartridge or supply paper during Energy Saver mode, the machine
does not identify these changes. Before performing these operations, exit Energy Saver
mode by pressing the <Energy Saver> button and the <Machine Status> button on the
control panel.
• Energy Saver mode is not exited by the following operations:
• Secure print
• Faxes stored in folders
• Direct fax
• Accessing a folder of the machine using CentreWare Internet Services
• When the following device is connected to the machine and a user performs the following
operation, Energy Saver mode can be deactivated without pressing the <Energy Saver>
button. If the machine is in Sleep mode, however, Sleep mode will not be deactivated by the
operation. By setting longer time to elapse until the machine enters Sleep mode, you can
make the machine to exit Energy Saver mode without pressing the <Energy Saver> button.
For more information on how to change the time to elapse until the machine enters Sleep
mode, refer to "Changing the Interval for Entering Energy Saver Mode" (P.25).
• Touch the card to IC Card Reader (optional).
• When the machine enters Low Power mode during a user is authenticated, the machine
exits authentication mode.