Replacing Booklet Staple Cartridge (For Booklet Maker Unit For Finisher-B1) - Fuji Xerox ApeosPort-IV 5070 Administrator's Manual

5
Insert the front side of the new staple case
into the staple cartridge (1), and then push
the rear side into the cartridge (2).
6
Push the staple cartridge into the finisher
until it clicks into place.
7
Close the finisher front door.
Note • If the finisher front door is not completely closed, a message will appear and the machine will
Replacing Booklet Staple Cartridge
(for Booklet Maker Unit for Finisher-B1)
When the Booklet Maker Unit for Finisher-B1 (optional) is installed and the staple
cartridge needs to be replaced, a message appears on the touch screen. When this
message appears, load a new staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and
Note • To order a staple cartridge, contact our Customer Support Center.
1
Make sure that the machine is not operating,
and open the finisher side cover.
2
Hold the tabs on both sides of the staple
cartridge and pull the cartridge out of the
finisher.
remain paused.
performance. Use only staple cartridges recommended by Fuji Xerox.
Replacing Consumables
2
1
3
69