Configuration Of Store To Wsd; Step 1 Preparations; Step 2 Enabling Port - Fuji Xerox ApeosPort-IV 5070 Administrator's Manual

9 Scanner Environment Settings

Configuration of Store to WSD

This section describes how to configure the machine to use the Store to WSD service.
The following shows the reference section for each procedure.

Step 1 Preparations....................................................................................................................328

Step 2 Enabling Port .................................................................................................................328

Step 3 Confirmation on the Computer ......................................................................................329
Step 1 Preparations
The following environment is required to use the Store to WSD feature on the machine.
The following operation system must be installed on a destination computer.
- Microsoft Windows 7
- Microsoft Windows Vista Service Pack 2
Step 2 Enabling Port
To use the Store to WSD service, enable the WSD scan port. The following describes
the configuration procedures on the machine.
Note
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter]. When a passcode is required, select
9
[Next] and enter the system administrator's passcode, and select [Enter].
Note
3) Select [Tools] on the [Services Home] screen.
2
Enable the port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [WSD], and then select [Change Settings].
4) Select [WSD Scan - Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.
3
Select [Close].
Note
4
Print a configuration report to confirm that the WSD port is set up correctly.
For information on how to print a configuration report, refer to "Print Reports" (P.87).
328
• You can configure the settings using CentreWare Internet Services. For information on how
to use CentreWare Internet Services, refer to "Configuring Machine Settings Using
CentreWare Internet Services" (P.273).
• The default user ID is "11111".
• The default passcode is "x-admin".
• Rebooting the machine may be required depending on the settings. When a message
displayed on the screen, follow the message and reboot the machine.