Emptying The Hole Punch Waste Container (For Finisher-B1) - Fuji Xerox ApeosPort-IV 5070 Administrator's Manual

3 Maintenance

Emptying the Hole Punch Waste Container (for Finisher-B1)

When the Finisher-B1 (optional) is installed and the hole punch waste container
becomes full, a message appears on the touch screen. When the message appears,
empty the hole punch waste container as instructed.
Make sure to discard all paper chads when emptying the hole punch waste container.
Not doing so will cause the container to fill up before the message telling you to empty
the container appears again, and this can cause machine malfunction.
Important • Empty the hole punch waste container when the machine is on. If you empty the container
1
Make sure that the machine is not operating,
lift the top transport cover, and then open the
3
front transport cover of the finisher.
2
Pull out the hole punch waste container.
3
Empty the container.
4
Insert the emptied hole punch waste
container into the finisher until it stops.
72
while the machine is off, the machine does not recognize that the container has been
emptied.
• When the machine is in Energy Saver mode, exit Energy Saver mode by pressing the
<Energy Saver> button and the <Machine Status> button on the control panel before you
empty the hole punch waste container.
• When you replace the hole punch waste container, press the <Machine Status> button and
check the current status for the hole punch waste container even when the control panel is
lit.
1
2