Changing The Interval For Entering Energy Saver Mode - Fuji Xerox ApeosPort-IV 5070 Administrator's Manual

Changing the Interval for Entering Energy Saver Mode

This section describes the procedures for setting Energy Saver mode.
To activate the Energy Saver, set the time to elapse until the machine enters Low
Power mode as well as the time to elapse until the machine enters Sleep mode.
Note • You can set the time to elapse until the machine enters Low Power mode and Sleep mode
1
Press the <Log In/Out> button.
2
Enter the system administrator's user ID with
the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next]
and enter the system administrator's
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3
Select [Tools] on the [Services Home]
screen.
Note • When the [Services Home] screen is not
4
Select [System Settings] > [Common
Service Settings] > [Machine Clock/Timers].
5
Select [Energy Saver Timers], and then
select [Change Settings].
Note • Select [
from 1 to 240 minutes in 1 minute increments.
displayed on the touch screen, press the
<Services Home> button.
] to display the previous screen
or [ ] to display the next screen.
Energy Saver Mode
1 2 3
4 5 6
7 8 9
0 #
C
<Log In/Out> button
1
25