Installation When Using Parallel Port; Step 1 Preparations; Step 2 Configuration On The Machine - Fuji Xerox ApeosPort-IV 5070 Administrator's Manual

Installation When Using Parallel Port

This section describes how to install the machine using a parallel interface.
Note • The parallel interface is not supported for some models. An optional component is required.
The following shows the reference section for each procedure.

Step 1 Preparations................................................................................................................... 281

Step 2 Configuration on the Machine ...................................................................................... 284

Step 3 Configuration on the Computer .................................................................................... 285
CentreWare Internet Services Setting Items ............................................................................ 285
Step 1 Preparations
The following items are required to connect the machine to a computer via a parallel
interface.
Parallel interface cable
The Driver CD Kit (provided with the machine or option)
Step 2 Configuration on the Machine
The following describes the configuration procedures to use a parallel interface on the
machine.
Note • You can configure the settings using CentreWare Internet Services. For information on how
1
Connect a parallel interface cable to the parallel interface connector on the machine.
2
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
3
Enable the parallel port on the machine.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [Parallel], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
to use CentreWare Internet Services, refer to "Configuring Machine Settings Using
CentreWare Internet Services" (P.273).

Installation When Using Parallel Port

7
281