Installing The Parallel Port Kit (Optional) - Fuji Xerox DocuPrint 3105 User Manual

A.8

Installing the Parallel Port Kit (Optional)

This section describes how to install the Parallel Port Kit (Optional) on the printer.
Parallel Port Kit (with frame)
Note
• The clamp that come with the option are not used with this printer.
Important
• Parallel Port Kit (Optional) and Gigabit Ethernet Board Card (Optional) cannot be installed concurrently.
If the Gigabit Ethernet Board Card (Optional) is installed, remove the card by reference to "Removing the
Gigabit Ethernet Board Card" (P. 348).
• When installing both the Parallel Port Kit (Optional) and Feature Enhance Kit, install the Feature
Enhance Kit first.
Installing the Parallel Port Kit (Optional)
1. Switch the power off by pressing the <
side of the power switch of the printer.
After checking that the display of the control
panel and the various lamps have switched
off, unplug the power cord from the power
outlet and the printer.
Note
• The electric parts on the inside of the right cover of the
printer can get very hot. Before installing extension
system memory, be sure to first switch off the power of
the printer, wait for approximately 40 minutes, and
check that the temperature inside the printer has
cooled down.
Connector conversion cable
>
A.8 Installing the Parallel Port Kit (Optional)
341