Greasing • Lock-Tight Parts - JUKI AMS-210E Series Engineer's Manual

(3) Greasing • lock-tight parts
1. When the parts for greasing and grease sealing-in are disassembled and the operational frequency seems to be
higher than usual around these parts, grease should be replenished once every two years.
2. Recommendable grease
This sewing machine uses four types of grease as specified below. The recommendable brands of grease are
listed in (4) Parts to which grease•lock-tight is applied. According to this information, replenish the most appli-
cable grease to these parts. 1 1 1 1 1
* Use Lithium Type consistency No. 2 for the parts where "Grease" is simply specified in (4) Parts to
which grease•lock-tight is applied.
1
Penetration No. 2 lithium grease
This type of grease is used in general sliding parts.
Maker name
Esso:
Shell:
Nippon Oil Co., Ltd.:
Kyodo Oil Co., Ltd.:
Idemitsu Petrochemical Co., Ltd.:
2
Templex N2 (Grease D) •••• Used for the feeding gear block.
10g tube JUKI Part No.: 13525506
3
JUKI Grease A •••• Used for high-speed sliding parts and their peripheral parts.
10g tube JUKI Part No.: 40006323
500g (IE-22) JUKI Part No.: 23640204
4
JUKI Grease B •••• Used, in particular, for the specific areas with highly loaded parts. Important: this
grease must be replenished at the specified intervals of period, according to "(5) Grease-up procedures
for the specified position."
10g tube JUKI Part No.: 40013640
3. Method of greasing
If no grease pump is available, fill a plastic oilcan with grease. Otherwise, an injector without a needle can be
conveniently used.
4. Miscellaneous
An injector to be used exclusively for coating / JUKI Part No. : GDS01007000
5. Application of Lock Tight
Apply Lock Tight 241 to section with the asterisk
Brand name
Listan 2, Beacon 2
Albania
Multinok 2, Epinok 2
Lisonix 2
Coronex 2
∗
.
– 187 –