Standard Adjustment - JUKI AMS-210E Series Engineer's Manual

3. Standard adjustment

(1) Main shaft connection/disconnection
1. Loosen the set screw
2. Loosen 2 set screws
On this occasion, loosen No. 2 set screw first, and completely remove No. 1 set screw from the flat part of the
main shaft .
3. Remove the main shaft motor
Refer to "3.-(2) Removal of the main shaft motor and coupling".
4. Loosen 2 set screws
On this occasion, be aware that the balancer
5. Loosen 2 set screws
6. Loosen 2 set screws
On this occasion, completely remove No. 1 set screw of the set screws
.
7. Loosen 2 set screws
8. Pull out the main shaft
Screwdriver hole A
No. 2 set screw
D
No. 1 set screw
Procedures of disassembling
securing the main shaft counterbalance
(through the screwdriver hole A), 2 set screws
.
.
.
.
and 2 set screws .
in the direction of Arrow C.
Main shaft taper hole
F
, and remove the taper screw
may rotate due to loosened set screws
No. 2 set screw
E
No. 1 set screw
– 5 –
, and 2 set screws .
.
from the flat part of the main shaft
No. 2 set
screw
C
No. 1 set screw
.