Greasing Parts - JUKI LK-1900AN Engineer's Manual

(3) Greasing parts

1. When the parts for greasing and grease sealing-in are disassembled and the operational frequency
seems to be higher than usual around these parts, grease should be replenished once in one to two
years.
2. Recommendable grease
This sewing machine uses four types of grease as specified below. The recommendable brands of
grease are listed in "(4) Parts to which grease is applied." According to this information, replenish the
most applicable grease to these parts.
* Use 1 Lithium Type Consistency No. 2 for the parts where "Grease" is simply specified in "(4)
Parts to which grease is applied."
1 Penetration No. 2 lithium grease (Grease)
This type of grease is used in general sliding parts.
Maker name
Esso
Shell
JX Holdings, Inc.
Idemitsu Kosan Co., Ltd.
2 Templex or Unirex N2, N3 (Grease D) ······· Used for the feeding gear block.
· 10g tube JUKI Part No.: 13525506
3 JUKI Grease A ······· Used for high-speed sliding parts and their peripheral parts.
· 10g tube JUKI Part No.: 40006323
· 100g tube JUKI Part No.: 23640204
4 JUKI Grease B ······· Used, in particular, for the specific areas with highly loaded parts.
Important: this grease must be replenished at the specified intervals of period, according to "(5)
Grease-up procedures for the specified position."
· 10g tube JUKI Part No.: 40013640
3. Method of greasing
If no grease pump is available, fill a plastic oilcan with grease. Otherwise, an injector without a needle
can be conveniently used.
· An injector to be used exclusively for coating / JUKI part No.: GDS01007000
Brand name
Listan 2, Beacon 2
Albania
Multinok 2, Epinok 2
Lisonix 2
Coronex 2
– 83 –