JUKI AMS-210E Series Engineer's Manual page 114

E
L
H
I
(2) CP-20
It is possible to make setting with the memory switches (Level 2) No. 300 to 401.
In regard to the method of input entry, refer to 4. Memory Switches, (2) Function list , • Level 2 (Simplified panel).
B
G
3) Port I/O setup
To make output number setting, input number set-
J
ting, and virtual I/O number setting, the setup button
function number (H) in the selected terminal through
K
the ten key (I). The signal type is selected from High
(J) and Low (K). In the case of virtual I/O number
setting, it is selected from output
To make switch operation setting, the setup button
(M) and Low (N).
M
N
– 109 –
F
(G) is pressed to enter an input of the setting
(L) is pressed to select the signal type from High
and input .