JUKI AMS-210E Series Engineer's Manual page 148

2) CP-2 (XY motor / origin sensor check)
The status of inching operation of the X/Y motor, operation of origin retrieval, and the X/Y origin sensors is
displayed.
1. In the first place, press the
thread trimmer motor. The presser assumes the lowering condition.
After the completion of preparation, the sewing LED is lit.
2. Operation
P 1 P 2 P 3
Using the Start SW, origin retrieval of the X/Y motors is effected for both shafts.
3) CP-3 (Continuous operation)
After the conditions of continuous operation have been set, the opera-
tional mode moves to the continuous operation mode.
To cancel the continuous operation mode, it is necessary to turn the
power supply OFF.
1. Rest time setting
Press the and
Setting is possible within the range of 0 to 9900ms in the unit of 100ms.
(Initial value 2000ms)
After the completion of setting, press the
2. Setting for the presence of origin retrieval at the end of sewing
Press the and
at the end of sewing.
A0: Ineffective (Initial value)
A1: Every 100 sewing cycles
A2: Every sewing cycle
key to carry out needle thread clamping and origin retrieval for the presser and
P 4 P 5
keys to set up the rest time.
key.
keys to set up the presence of origin retrieval
According to the status of the selected X/Y origin sen-
sor, "0" or "1" is displayed. The
make changeover.
Using the and
motor in the direction of +/– by 0.1mm each time.
(Caution) Since the circular interpolation system is
used, any motor not selected is also driven.
The selection status of the X motor (X origin sensor) or
the Y motor (Y origin sensor) is displayed. The
is pressed to make changeover.
X enlargement/reduction scale rate LED lit: X motor (X
origin sensor)
Using the key, the selection status of the X motor
(X origin sensor) or the Y motor (Y origin sensor) is
changed over.
– 143 –
key is pressed to
keys, drive the selected X/Y
key