JUKI AMS-210E Series Engineer's Manual page 151

5) CP-5 (Output check)
1. Operation
An output is generated while the
P 1 P 2 P 3
6) CP-6 (Presser and thread trimmer motor / origin sensor check)
The status of inching operation of the presser and thread trimmer motor, operation of origin retrieval, and the
presser origin and thread trimmer sensors is displayed.
1. READY operation
In the first place, press the
After operation for preparation, the sewing LED is lit.
2. Operation
P 2
P 1 P 3
The START Switch is used for the origin retrieval of the presser and thread trimmer motor.
P 4 P 5
key for the origin retrieval of the needle thread clamp.
According to the status of the thread trimmer sensor, "0" or "1" is displayed.
According to the status of the presser origin sensor, "0" or "1" is displayed.
P 4 P 5
key is pressed.
The checking items can be changed with the
keys.
In regard to the items, refer to the section of IP-400 output
check.
Using the and
trimmer motor can be driven by one pulse in the +/– di-
rection.
The key is used to drive the presser and thread
trimmer motor to each preset position.
1
Presser lifting position
2
Presser lowering position (lowering position during
pedal operation)
3
Thread trimmer position
4
Presser lowering position (lowering position after
thread trimming)
When the
kept pressed, the motor is driven reversely.
– 146 –
keys, the presser and thread
key is pressed while the
and
key is
P 5