JUKI AMS-210E Series Engineer's Manual page 145

Check program number
6. Press the key to define the check program number.
7. When the key is pressed for each check program, the current check program is completed and the status
of 5. is recovered.
Once the continuous operation mode is started, it cannot be canceled. To complete it, however, it is necessary to
turn the power supply OFF.
Check program
Output check
Presser, thread cutter motor/
origin sensor check
Needle thread clamp motor/ The status of inching operation of the needle thread
origin sensor check
Intermediate presser
adjustment
Software version display
The wiper and air outputs are generated.
The status of inching operation of the presser and
thread trimmer motor, operation of origin retrieval, and
he presser origin / presser sensors is displayed.
clamp motor, operation of origin retrieval, and the needle
thread clamp origin and needle thread clamp sensors is
displayed.
The status of inching operation of the intermediate
presser motor, operation of origin retrieval, and the
intermediate presser origin sensors is displayed.
The software versions of the MAIN and SDC boards
are displayed.
– 140 –
Contents