Method Of Confirmation According To Each Test Program No. (Cp-20) - JUKI AMS-210E Series Engineer's Manual

(3) Method of confirmation according to each test program No. (CP-20)

1) CP-1 (Input signal check)
It is possible to check the input status of the operation panel keys, pedal switches, and various sensors.
P 1 P 2
Contents of Display for each Input No.
Pattern X enlarge Y enlarge
LED LED
1
2
3 DIPSW2 DIPSW2 DIPSW2 DIPSW2 Start SW
-1 -2
4 AUDET ADDET
Sensor Sensor
5 Y motor Presser motor Thread clamp Intermediate
origin origin
sensor sensor
6 External External
input 5 input 6
7 External External
input 15 input 16
8
DIPSW2 is a dip switch located on the MAIN board.
P 3 P 4 P 5
Speed
LED LED
Key Key
P 5
Key Key
-3 -4
DDET UDET
Sensor Sensor
motor presser motor
origin sensor origin sensor
External External
input 7 input 8
Display of input No.
The input number is updated by +1 each time the
and keys are pressed simultaneously.
Display of the input status with the item selection LED
ON/OFF
Refer to the table below in regard to the contents of dis-
play.
Counter Bobbin Threading Thread tension
LED LED
Key Key
Key Key
Presser Presser
1SW
TG PDET
Sensor Sensor Sensor
Presser Thread External External
motor clamp motor input 1
sensor sensor
External External External External
input 9 input 10 input 11 input 12
– 142 –
Ready
LED LED LED
Key Key
Key Key
Presser Presser
2SW 3SW 4SW
SDET Head fall Air pressure X motor origin
SW SW
External
input 2 input 3
External
input 13
Thread clamp
LED
Temporary
stop
SW
Sensor
External
input 4
External
input 14