JUKI AMS-210E Series Engineer's Manual page 152

7) CP-7 (Needle thread clamp motor / origin sensor check)
The status of inching operation of the needle thread clamp motor, operation of origin retrieval, and the thread
clamp origin and needle thread clamp sensors is displayed.
1. Operation
P 1 P 2
The START Switch is used for the origin retrieval of the needle thread clamp motor.
8) CP-8 (Intermediate presser adjustment)
The status of inching operation of the intermediate presser motor, operation of origin retrieval, and the thread
clamp origin and intermediate presser origin sensor is displayed.
1. Operation
P 1 P 2
The START Switch is used for the origin retrieval of the intermediate presser motor.
According to the status of the needle thread clamp sensor, "0" or "1" is dis-
played.
According to the status of the thread clamp origin sensor, "0" or "1" is dis-
played.
P 3 P 4 P 5
According to the status of the intermediate presser origin sensor, "0" or "1" is
displayed.
P 3 P 4 P 5
Using the and
motor can be driven by one pulse in the +/– direction.
The key is used to drive the needle thread clamp
motor to each preset position.
1
Standby position (front side)
2
Needle thread bending position
3
Needle thread clamp position
4
Refuge position (rear side)
Using the and
motor can be driven by one pulse in the +/– direction.
The key is used to drive the needle thread clamp
motor to each preset position.
1
Lower position at the height of 7mm during lowering
2
Timing adjustment position
3
Lower position at the height of 0mm during lowering
4
Intermediate presser bar adjustment position
– 147 –
keys, the needle thread clamp
keys, the needle thread clamp