JUKI AMS-210E Series Engineer's Manual page 47

1. Hold down the X fixed race (rear)
tighten 4 set screws
2. Loosen 4 set screws
3. Hold down the X fixed race (front)
tighten 4 set screws
torque between 9.8 to 39.2 N (1 to 4 kgf) on both right and left sides.
4. Tighten 4 set screws
* Retainer compensating torque: This is a load necessary to move the
race table after the retainer
stopper .
This torque should be measured when the belt is slack before pulse
motor installation.
Adjustment Procedures
in the direction of the arrow to
.
.
in the direction of the arrow to
. * Then, adjust the retainer compensating
.
has come in contact with the X
– 42 –
Results of Improper Adjustment