Greasing• Lock-Tight Parts - JUKI AMS-221EN Series Engineer's Manual

(3) Greasing • lock-tight parts
1. Grease should be replenished at the time of cleaning or air blow when the greasing and grease seal-in parts are
disassembled and their operational frequency seems to be higher than standard.
2. Recommendable grease
This sewing machine uses five types of grease as specified below. Juki Grease A and B are installed inside the
1 1 1 1 1
sewing machine. (Refer to "(5) Replenishing the designated place with grease" for more details.)
* Use Lithium Type consistency No. 2 for the parts where "Grease" is simply specified in (4) Parts to
which grease•lock-tight is applied.
1
Penetration No. 2 lithium grease
This type of grease is used in general sliding parts.
Maker name
Esso:
Shell:
Nippon Oil Co., Ltd.:
Kyodo Oil Co., Ltd.:
Idemitsu Petrochemical Co., Ltd.:
2
Templex N2 (Grease D) •••• Used for the feeding gear block.
10g tube JUKI Part No.: 13525506
3
JUKI Grease A •••• Used for high-speed sliding parts and their peripheral parts.
10g tube JUKI Part No. : 40006323
100g tube JUKI Part No. : 23640204
4
JUKI Grease B •••• Used, in particular, for the specific areas with highly loaded parts. Important: this
grease must be replenished at the specified intervals of period, according to "(5) Grease-up procedures
for the specified position."
10g tube JUKI Part No.: 40013640
5
Grease (for LMguide) •••• Used for the LM guide
70g tube JUKI Part No.: 40097886
3. Method of greasing
If no grease pump is available, fill a plastic oilcan with grease. Otherwise, an injector without a needle can be
conveniently used.
4. Miscellaneous
An injector to be used exclusively for coating / JUKI Part No. : GDS01007000
5. Application of Lock Tight
Apply Lock Tight 241 to section with the asterisk
Brand name
Listan 2, Beacon 2
Albania
Multinok 2, Epinok 2
Lisonix 2
Coronex 2
∗
.
– 190 –