JUKI AMS-210E Series Engineer's Manual page 67

1. Push the needle thread clamp device
hinge screw .
2. Turn on the power supply and press the
complete is positioned at the far advanced end.
Confirm that the distance between the needle thread clamp support plate complete
3.3 to 3.7mm and 1.7 to 2.3mm, respectively.
3. If the distance seems to be inadequate, loosen the four set screws
device for adjustment.
(Caution) For the prevention of injury, the distance should be checked only if the sewing LED is unlit.
(Press the
4. After the completion of the above-mentioned reassembly, make adjustments according to "(41) Adjusting the
needle thread clamp sensor."
Procedures of assembling
in the direction of A and fix it with the four set screws
key twice so that the needle thread clamp support plate
key twice after the power supply has been turned on.)
– 62 –
and move the needle thread clamp
3.3 to 3.7mm
. Tighten the
and the needle is