JUKI AMS-210E Series Engineer's Manual page 11

1. Insert the main shaft
wheel , and main shaft counterbalance
2. Tighten the taper screw
the main shaft counterbalance
3. Lightly press the main shaft counterbalance
direction of Arrow E, and tighten 2 set screws
(Tighten No. 1 set screw so that it touches the flat part of the main shaft
Same procedure hereafter)
4. Tighten 2 set screws
main shaft .)
5. Press the hand pulley
gear B , and secure them with 2 set screws
6. Mount the main shaft motor
Refer to "3.-(2) Removal of main shaft motor and coupling".
7. Secure the eccentric cam of the intermediate presser
of intermediate presser cam".
8. Secure the crank rod
9. Secure the balancer
10. Secure the bobbin winding drive wheel
winder driveing wheel poition".
* Make sure that no torque is applied by rotating the main shaft
Procedures of assembling
into the crank rod , balancer
in this order, and mount this assembly on the frame.
into the taper hole of the main shaft
.
and 2 set screws . (Make sure that No. 1 set screw touches the flat part of the
in the direction of Arrow F to engage the hand pulley gear A
and coupling
with 2 set screws . Refer to "3.-(3) Crank rod connection/disconnection".
with 2 set screws . Refer to "3.-(4) Crank balancer positioning".
with 2 set screws
, hand pulley gear A
, and tighten the set screw
in the direction of Arrow D and the middle metal
.
.
.
with 2 set screws
. Refer to "3.-(34) Adjustment of the bobbin
.
– 6 –
, bobbin winding drive
to secure
. Then, tighten No. 2 set screw.
with the hand pulley
. Refer to "3.-(5) Adjustment
in the