Communication Programming; Keypad Programming Procedure - ADEMCO Vista-20 Installation Instructions Manual

Communication R ~~
Introduction
This sectionprovides instructions for programming those fields that affect communications
betweenthe controland the central station.
Keypad Programming Procedure
1. With at least one Alpha keypad (5137AD or 6139) connectedto the
system,power up the system. If necessary,refer to the
POWERING
THE SYSTEM
section for the power-up procedure If you had
previously connectedthe AC transformer to the control panel, you
need only plug in the transformer (to 120VAC outlet) to power up the
system.
2. Enter the programming mode by keying the following on the Alpha
keypad Installer code (41 12) + 80 0.
Press M PABX ACCESS CODE.
Fields * 40,*41.*42:
Enter up to the n~ber oi
digits shown. Do not fill
unused spaces.
Enter k9,
#+llfor'*'
# + 12 for '#'
# + 13 for a pause
(2.5 sees)
Press *41
-S *42
Press *43
Press *44
Press *45
%(2SS * 46
~
Enter up to 4 digits if PABX is needed to
accessan outside line. If fewer than 4 digits are needed to be
entered, etit by pressing * and next field number (e.g., 41). To
clearentries fkom field, press*40*.
~~
PHONE No.
1111 [111111
Enter up to 12 digits.
If fewer than 12 digits entered,exit by pressing * snd next field
number (e.g., 42). To clearentries tlom field, press* 41*s
SECONDARY PHONE No.
11111111111
I Enter up to 12 digit~.
If fewerthan 12 digits entered,exit by pressing * and next field
number (e.g., 43). To clear entriesfrom field, press * .42*.
For Fields *43, *44, *45,
and *
46.
Entries are provided for 3 or 4 digits for the primary and
secondarymonitming location.
Enter
digits O-9; #+10 =
A (O on some receivers); #+11 = B;
#+12 =C; #+13 =D; #+14= E;or#+15=F.
To clearentries born field, press* 43*, * 4zW, * 45*, or * 46*.
See blank Programming Form for examples of Account No.
enties.
PRIMARY SUBSCRIBER ACCOUNT. No. (Partition 1)
~]
(PrinmryCentialSt ationAccountNuxnber).
SECONDARY SUBSCRIBER ACCOUNT. No. (Partition 1)
~1 (SecondaryCentral StationAccountNumber).
PRIMARY SUBSCRIBER ACCOUNT. No. (Partition 2)
~1 (PrirnsryCentral StationAccountNumber).
SECONDARY SUBSC~ER ACCOUNT. No. (Partition 2)
Ill
1 (SecondaryCentral Station AccountNumber)
Press *47
PHONE SYSTEM SELECT
Enter 1 digit (default= O) U
If Central Station Receiveris
not
on
WATS
line:
O= Pulse Dial, 1 = Tone Dial.
If Central Station Receiveris on WATS line:
2 = Pulse Dial, 3 = Tone Dial.
-76-