ADEMCO Vista-20 Installation Instructions Manual page 26

m,
Enter the partiti~n to which this zone is
assigned, "1" or "2". The factory default is
partition 1. Press [*I to continue.
ml for~~d[~][~]forct. R~~er~o&ct&m17
The report codeconsistsof 2 hexadecimaldigits,
eachin turn consistingof 2 numerical digits. For
example, for a report codeof 3C , enter
[01[31
SYSTEM COMMUNICATION
for complete
information on report codes, if necessary.
Enter the desired report codeand then press [*I
to continue.
-l ~~%~$~$5~0-=10m~e~,u~=
Enter the desired response time for the zone.
Press [*I ~o continue.
T@ical summarydisplay
-l ~on,ue
A summary dispIay will appear, showing the
data for the zone that wasjust programmed.
If It IS programmed satisfactorily, press [*I to
UIEEEIl
The next request is to enter Alpha descriptors
for the zones. The entry may be done now (enter
1) or may be done at a later time using *82
interactive mode (enter O).We recommend that
the entry of Alpha descriptors'be done using %2
mode.
See
Section 15. ALPHA DESCRIPTION
PROGRAMMING for specifi procedure
a.one.s.~ca.dpre.ously
If "O* (no) was entered above, the system will
return to the Enter Zone Number prompt.
Proceed vmth the programming for the next
Whe~ you have programmed all the hard-wired
zones satisfactorily, exit *56 interactive mode at
the Enter Zn Num. prompt by pressins [01[01*
Then exit the programming mode by keying -.
Proceedto the check-outprocedurethat follows.
-26-