Programming The Control For Phons Access - ADEMCO Vista-20 Installation Instructions Manual

Programming The Control For Phons Access
1.
With at least one 2-lke Alpha keypad (5137AD or 6139) connected to the
Partition 1 keypad terminals on the control, power up the system
temporarily. If you had previously connectedthe AC transformer to the
contxolpanel, you need only plug in the transformer (to 120VAC outlet)to
power up the system.
2. Enter the programming mode by keying the following on the Alpha
keypad Installer code (411 2)+ 8 + O + O.
3. Press=. VOICE MODULE ACCESS CODE.
I
1
If using a 4285 Voice Module, enter the 2-digit phone accesscode as
follows: For first digit, enter 1-9; for seconddigit, enter # +11 for '*", or
# +12 for "#". Example: if desired accesscodeis 7* , 7 is the first entry,
and # + 11 (for*) is the secondentry.
Enter "00"if not using a VoiceModule (this is the default).
4. Press W5. RING DETECTION COUNT.
I
I
Refer to the chart belowand program this field accordingly.
Voice Answering
Module
Machine Downloading Field *5 Programming
Yes
No No Setforvalueotherthan"O"
(1-15).
This will
enablethecontrol p anelto
anewer thephonecall. Otherwise, it
will not be possibleto access the
VoiceModule.
Yes
Yes No Set for a value higher than the
number of rings for which the
answering machine is set. Example
if machineis set for 4 rings, usea
value of 5 or higher.This is recom-
mended so that the VoiceModule
canstillbe accessed if theanswering
machineis turned off and doesnot
answer thephonecall.
Yes
No Yes
Setfor valueotherthan"O"(1-15).
Yes Yes
Yes Enter "15"to bypassthe answering
machine.
5.
Zone destiptors should also be programmed, regardless of the type of
keypads in use. If this is not done,the Voice Module will not annunciate a
description of the zone(s) in alarm, trouble, etc. (the Voice Module will
annunciatezone numbers only).
You can enter zone descriptorsnow using interactive mode *82, or later.
See the
Section 15. ALPHA DESCRIPITON PROGRAMMING
for a
detailedprocedure.
6. Exit the progr arnming modeby entering $1%1.
Perform a prelimkary checkof the 4285 Voice Module, as indicatednext.
--s3-