Programming The Receiver And Transmitters; Rf House Id Code - ADEMCO Vista-20 Installation Instructions Manual

Programming g the Receiver and Transmitters
1. With at least one 2-line Alpha keypad (5137AD or 6139) connectedto the
Partition 1 terminals, power up the system temporarily. If you had
previously connectedthe AC transformer to the control paneI, you need
only plug in the transformer (to 120VAC outlet) to powerup the system.
2. Enter the programming mode by keying the following
Installer code(4112)+ 8+0+0.
3. *24. RF HOUSE ID CODE
m
The House ID identifies wirelesskeypads.
If a 5827 or 5827BD Wireless keypad is to be used, a House ID code
MUST be entered (01-31), and the keypad should be set to the sameID.
If no wirelesskeypad is to be used, enter "00".
Partition 2 House ID is automatically set for one number higher than the
ID number entered for Partition 1. Therefore, if a wirelesskeypad is also
used in partition 2, the House ID for partition 1 must not be higher than
30.
4. Press *56.
(ZoneProgramming Mode)
Use this mode to program zone numbers, zone types, partition numbers,
alarm report codes, and to learn RF devices for all wireless expansion
zonesthat are going to be used in the system.
w
IMPORTANCE
If
wiredexpansion zonesare not presently being
usedin the system, b ut if thereis any possibilim
that they may be addedat somefkturedate,you
shouldassignzonenumbersin the range of 16-
63for wireless transmitters.
Thereasonfor thisis as follows: w iredexpansion
zone numbers are restrictedto 10-17; if you
assign zone numbers between 10 and 17 for
wireless, a nd subsequently add wiredexpansion
zones, all serial numbers for wireless
transmittersin the 10-17 zone number range
will be lost. and any transmittersassignedto
those numbers will becomeinoperativein the
system.Theseparticulartransmitterswill then
have to be assignedMerent zonenumbers(in
the rangeof 16-63) end their serialnumbersre-
learned.
~,
Enter the zone number that you wish to
program. As an example, zone 20 is shown
entered.
You can assign zone
numbers
to Ixansmitters as
follows:
Use zone numbers in the range of 10-63 if a
4219 or 4229 is NOT being used in the
system.
Use zone numbers in the range of 18-63 if a
4219 or 4229 IS ALSO being used in the
system,
even if some of the expansion unit's
wired loops are not being used.
The actual number of zones that can be
assignedto wirelessis
24,
but will be lessif a
wired expansion module is being used (see
"General Information" at the beginning of
this section).
Note:
M?ter
If using a button for arming, the zone
number assigned to the button is the
"user number" reported to the central
skm-rnstation, i.e., arm button = zone x,
disarm button = zoney.
entry of zone number, press [*I to
continue.
A summary display will appear, showing the
status of that zone's program.
If it is programmed satisfactorily, press [#l to
back up one step and enter another zone
number, if desired.
If the zone is not programmed, or you want to
change it, press [*]. A prompt for Zone Type
will appear.