ADEMCO Vista-20 Installation Instructions Manual page 37

J.
Zone Number
a
II
20
Partition
II
II
20 Report Code
lst03 2nd12 3C
II
II 20 Input Type
RF Trans. RF: - II
II
20 Learn S/N ?
o =No
1 = Yes O
II
-37-
Each zone must be assigneda zone type, which
definesthe way in which the systemresponds to
faults in that zone:
Enter the zonetype (or change it, if necessary).
Zonetypes that you can assign are listed below.
A detailed explanation of each zone type is
provided in
Section 18. ZONE RESPONSE
TYPE DEFECTIONS.
Enter the desiredzonetype codeaa listed below.
00= ZoneNotUsed 09= Fire
01= Entry/Exit#1
10= Interiorwlllelay
02. Entry/Exit#2 20= kln-sta~
03= Perimeter
21= ArmAway
04= InteriorFollower
22 = Disarm*
05= Trouble Day/Alarm Night 23='0 _
06= 24Hr Silent .
Response
07= 24Hr Audible
(EK
Relay
activation)
08=24 HrAux
24= SilentBurglary
* These arespecial zonetypesusedwith5800series
wirelesspushbuttonunits which will result in
a@ng -tiesystem in theSTAYorAWAY mode,or
&sarmmg of the system, depending on the
selection m ade.
A button programmed for these functionswill
report zonenumber as the user number to the
central s tation.
When the display showsthe zone type you want,
press[*] to continue.
Enter the partition
assigned,"l" or "2.
Press [*] to continue.
Enter the report code.
to which this zone is
See Section 17. SXSTEM COMMUNICATIONS
for complete information on report codes, if
necessary.
Press [*] ta continue.
For a 5800 system's transmitters, "RF" is
initially displayed.
The 5S00 Series Transmitters Table" at the
end of this programming section shows the
'Tnput Type"to be enteredfor eachtransmitter.
Enter the appropriate Input Type for the
transmitter being programmed.
9=supervised RFtranaml utter(RF type)
4 = unsupervisedRF transmitter (UR @pe)
5 = RF button me transmitter (BR type)
Press [*] to continue.
At this point, install a battery in the
tr ansmitter to be learned (not applicable to
ha.munitterswith permanently builbin batteries
such as 5802/5802CP and 5803). See note on
next page.
The transmitter serial number can be learned
here or via *83 mode, or entered via the down-
loader). We recommend you use *83 mode if you
are only changing a wireless transmitter, and
wish to maintain the other zone parameters.