ADEMCO Vista-20 Installation Instructions Manual page 38

II
TRANSMIT NOW
II
If "yes" is selected'in response to the "Learn
MN?" prompt, this display will appear.
Fault and restore the transmitter to be learned.
A simzlebee~ will be heard at the kevoad. Wait
68 s~conds.'~ault and restorethe tr=mitter a
secondtime. 'IWObeepswill be heard, indicating
acceptance into the system.
Note If a long beep occurs,it means that the
particular transmitter input has
previously been registered in the
system.
Mark the zone number on the transmitter. If the
transmitter is a multi-button @pe, each of the
buttons used must assigned to a different zone,
and each of the buttons must be learned.
Typical summarydisplay
m
Accspted Input (Loop) Number
II Program Alpha?
o =Nol= Yes O I
II
Enter Zn Num.
(00 = Quit)
21
I
After a transmitter has been learned, a
summary of the programmed values for the
selected zone will be displayed.
If all is okay, press [*].
Alpha descriptorsfor the zones can be done now
(enter 1) or maybe done at a later time using
*82 interactive mode (enter O). We recommend
that the entry of Alpha descriptors be done
using *82 mode.
Refer to
Section 15. ALPHA DESCRIPTION
PROGRAMM~G
for specificprocedure.
If you entered 'O* (no) in response to the
Program
Alpha ?
prompt, the system will
display a prompt for entry of the number for the
next wirelessexpansionzone to be programmed.
Proceedwith the progrsmming of the next zone,
as indicated previously.
5.
Exit the programming g modeby keying $H19.
6. Use the transmitter Sniffer mode to test that all transmitters have all
been programmedproperly, as indicated next.