4285 Voice Module; Installing The Voice Module; Mounting The 4285 Voice Module - ADEMCO Vista-20 Installation Instructions Manual

—
This section provides instructions for mounting the 4285 Voice Module,
wiring the VoiceModule and for programming the system for phone access
via the VoiceModule.
Inetalbg the Voice Module
MomBation
The 4285 VoiceModule is an add-on accessory for the VISTA-20 that permits
accessto the security system via a Touch-tone phone (either on premises or
by a call-in when away).
The Voice Module can announce many of the same words that would
normaUy be displayedon an Alpha keypad under the same systemconditions.
When properly connected,the 4285 Voice Module will enable the user to do
the following via a Touch-tonetelephone
a.
Receivesynthesizedvoicemessagesover the phone regardiug the statue of
the securitysystem.
b. Arm and disarm the securi~ system and perform most other commands
using the telephonekeypad, with voice annunciation being provided over
the phone as confirmation after any commandis entered.
The phone used for phone accessmust have Touch-tone capabili@, though
Touch-tone service is not necessary (if premises uses PULSE dialing,
switchablephones must be set for Touch-tone temporarily before attempting
phone access).
A Phone Access User's Guide
for phone accessto the securi@ system is
provided with the VoiceModule for the user of the system.
Mounting The 4285
Voice Module
The
Voice Module may be mounted in the control cabinetif spaceis available
or, if this is not possible,on the side of the cabinetor adjacentto it.
When mounting the Module outside the cabinet, use the screw" holes at its
rear which will permit it to be mounted horizontally or vertically (2-faced
adhesive tape may be used, if preferred). Wires can be brought out fkom the
side or back (a round breakout is also available on the back).
Af6x the VoiceModuIe's connections label (supplied separately)to the inside
of the Voice Module's cover if the cover is used. If you have installed the
module within the cabinet, aflix the label to the inside of the control cabinet's
door.
-50-