Split/Dual Reporting; 15-Second Dialer Delay; Periodic Test Report; Test Report Offset - ADEMCO Vista-20 Installation Instructions Manual

ZnZTPRC In: L
20 091 10
RF:-
1
*50
*5 I
*52
*53
*56
SPLI!UDUAL REPORTING
c!
Enter Oto disable (Backup report only). This is the defaulk
I To
PRIMARY To SECONDARY
1=
Alarms,Restore,cancel
Others
2 = All except Open/Close, T est
Open/Close, Test
3= Alarms,Restore, c ancel Au
4=
All except O pe n/Close, T est
All
5=
Au
All
15-SECOND DIALER DEI.AY (BURGI.AltY)
If selected,will provide 15-seconddelay of burglary alarm report to
the central station. Allows time for subscriberto avoid a false alarm
transmission.
Enter Ofor no or 1 for yes. Default is O (no delay).
Enter "o" for UL installations.
PERIODIC TEST REPORT
Selectthe desired test report interval.
O= none; 1 =24 hours; 2 = weel.d~3 = 30 days. Default is O (none).
Test Report Code enteredin field *64 is sent.
Reportswith Partition 1 SubscriberNo.
TEST REPORT OFFSET
LJ
This
is the time to first report from programming g or downloading.
O=24 hours; 1 = 6 hours; 2 = 12 hours; 3 = 18 hours. Default is 2.
SESCONRADIONICS SELECT
u
O =
Radionics(O-9, B-F reporting)
1 = SESCOA (O-9 only reporting)
SelectOfor all other formats.Default is O.
ZONE
ASSIGNMENTAIARM REPORT CODES
(and RF Input ID Learn@g for 5800 System)
REFER TO THE ZONE ASSIGNMENT TBLE FOR *56 IN THE
CENTERFOLD PROGRAMMING FORM .
This
is an interactive menu mode that is used to program zone
numbers, zone types, partition numbers, alarm and report codes,and
to ident@ the @pe of loop input device.This mode can Z&SO be used
for "learning" 5800 seriestranemi tter ID codesand for entering Alpha
descriptors for zones (we recommend entering descriptors in menu
mode*2.
Upon entry menuu mode *56, the foIlowingis displayed:
Zone Number (Zn): Enter the zone number that you wish to
program (or [0][0] to leavezone progrsmmin g).
Press [*]. A summary display will comeup, showingthe status of that
zone'sprogram.
If it is programmed satisfactorily,press [#] to back up one step and
enter another zone number, if desired.
If the zone is not programmed, or you want to changeit, press [*]. A
prompt for Zone be will appear.