Voice Module Wiring - ADEMCO Vista-20 Installation Instructions Manual

Voice Module W-
The 4285 is
wired betweenthe controlpanel end the premiseshandset(s). It
listens for touch tones on the phone line and reports them to the control
panel. During on-premises phone access,it powers the premises phones;
during off-premisesphone access, i t seizesthe line Ikomthe premises phones
and any answeringmachines.
Note: The phone lines must be in servicefor the voicemodule to fi.mction,
even when accessing the systemborn an on-premisesphone.
1. Make 12V (+) and (–) and data in and data out connections fkomthe Voice
Module to the control, using the connectorcablesupplied with the Voice
Module (seeFigure 16). -
ColorLead TerminalOn Control*
*
GREEN DATA IN (terminal 6)
>
BLACK I AUX - (teminal 4)
J
IRED
I AUX+[termina15) I
--
These are
the same
connections as those
usedfor remote ke~ads
connected to Partition1.
YELLOW
I
DATA OUT (terminal 7 )
2. Insertthe
keyed connectorat the other end of the connectorcableinto the
mating header on the VoiceModde (seediagram on next page for location
of the header).
3. Connect
terminals 1 through 5 on the Voice Module as shown in the
Wiring Table belowand in the 4285 wiring diagram that follows.
428!5WIRLNG
TABLE
4265
Terminal
COnneots *.
1.
Phone In (Tip) Terminal (21)on control.
2. Phone In (Ring) Terminal (22)on control.
I S. PhoneOut (TiD) I BROWNleadflom direckonnect cord.I
4.
PhoneOut (Ring) GRAYleadborn direct<onnect cord.
5. Ground Earthgroundterminal(25)oncontrol.
6.
Not Used
7. Not Used
Caner munits
If the telephone systemon the premisesincludes a Caller ID unit, connectthe
unit directly to the %andsetm temrinals (21 & 22) On tie con~ol~ as
shownin 4285 VoiceModule Wiring Connectionsdiagram that follows.
-!51 -