ADEMCO Vista-20 Installation Instructions Manual page 14

Mounting Control and RF Receiver Ckuit Boarda Togetbr, b the Cebmet
1.
2.
3.
4.
5.
6.
7.
8.
Hang two
short
(black) mounting clips (provided with receiver) on the
raised cabinettabs,as shown in Detail B in Figure 3.
Insert the top of the receiver board (removed from its own case as de-
scribed in its instructions) into the slots at the top of the cabinet, as
shown in Detail A in Figure 3. Make sure that the board rests on the cor-
rect row of tabs,as shown.
Swing the baseof the board into the mounting clips and secure it to the
cabinetwith the accompanyingscrews (seeDetail Bin Fig. 3).
Insert the top of the control'sboard into the slot in the clips and position
two long (red) clipsat the lower edgeof the board (seeDetail C).
Swing this boardinto placeand secureit with two additional screws.
Insert grounding lugs (supplied with the receiver)through the top of the
cabinetinto the left-hand terminals of the antenna blocks(at the upper
edge of the receiverboard) and securethem to the cabinettop with the
screwsprovided,as shown in Detail D.
Insert the receiver's antennas through the top of the cabinet,into the
blocks'
right-hand
terminals, and tighten the screws.
Refer to the WIRELESS ZONE EXPANSION sectionfor setup and wiring
of the receiver.
i4vLEs mm AN7HNWS
AND GROIJNLWJC LUGS
SOAm SUPPOSTING SLo'rs
RESEIESEII
Uncul-f
MAW
SoARo
DC-rut A
sJcnEmEw OF
BoARo wPPORllNG SLOB
SHORT(sIA@ MOUNTINGCLIPS >
COwROl.
w-y
LONG(FEO)MOUNTINGCLIPS
@
@
ILu
T
Oc?m
m
S40E
WEW
OF
- MOUNTING CLIPS
~
SCREW
OrrAIL c
~ ANTENNA
SIDEVIEW of
e
LONG MOusnw CLIPS
V/
GROUNOING LUG "
h— :'::
'f=
Figure 3.
Mounting 7be PC Board And RF Receiver Together In lb Cabinet
-14-