Mounting The 5800Tm Module; 5800Tm Wiring Connections; 5800 Series Transmitters; Transmitter Supervision - ADEMCO Vista-20 Installation Instructions Manual

Instalbg the 5SOOTM Module
Installation of this module is necessary only if you are using one or more
5827BD Wireless Bi-directionalkeypads.
Note: The 5827BD wiIl only receivesignals for"partition 1.
Motmting the
5SOOTM Module
The 5800TM must be locatednext to the RF receiver (between one and two
feet born the receiver'santennas). The 5800'I!M must not be installed within
the control cabinet. Mount the unit using its accompanying mounting
bracket.
5SO07M W*S
COfmedions
Connect
the 5800TM to the control panel's keypad connection terminals,
using the suppliedconnector with flying leads, as follows:
WIRE TERMINAL ON CONTROL
BLACK (Ground): Terminal4
RED (+12VDC) Terminal5
GREEN (Datato Control)
Terminsl6
YELLOW (Datafimm Control)
Terminal7
BLUE: NotUsed
Do not cut any of the jumpers on the 5800TM when using it with the
Vista-20.
For additional information, refer to the 5800TMs inshmtions.
5800 Series Transmitters
5800 series
transmitters have built-in serial numbers that must be "learned
by the systemusing the *56 or *83 interactive mode, or input to the control
via the downloader. 5800 series transmitters (except 5827 described
separately) do not have DIP switches.
Each transmitter's zonenumber is programmed into the systemin *56 mode.
Some transmitters, such as the 5816 and 5817, can support more than one
"zone" (referred to as loopsor inputs). On the 5816 for example, the wire con-
nection terminal blockis loop 1, the reed contactis loop 2. Each loop must be
assigned a difFerentzonenumber.
For button transmitters (RF "keys"), such as the 5803 ~d 5801, YOUmust
assign a unique zone number to each individual button used on the
transmitter. Each button on the transmitter also has a pre-designated loop
or input number, which is automaticallydisplayed.
Programming an RF House ID (01-31) in field *24 is necessary only if
using 5827 or 5827BD wireless keypads. An RF House ID is not
necessaryfor other 5800 series transmitters and the entry should be left at
'00" (default) in thosecases.
The 5827 reportslow battery status as zone "00."
Transmitter Sal m==-
Except for some transmitters that may be carried off-premises (5802,
5802CP, 5803, and 5827, and 5827BD), each transmitter is supervised by a
check-in signal that is sent to the receiver at 70-90 minute intervals. If at
least one check-in is not receivedfrom each
supervised
transmitter within a
12-hour period, the "'missing"transmitter number(s) and "CHECK" will be
displayed.
The supervision for a particular transmitter in the system that may also be
carried off the premises(5801, 5802MN) maybe med off by leg it as a
"UIt" (unsupervisedRF) type, as describedlater,
5800 seriestransmitters have built-in tarnper protectionand will annunciate
as a "CHECK!' conditionif coversare removed.