4285 Wiring Notes; 4285 Voice Module Wiring Connections - ADEMCO Vista-20 Installation Instructions Manual

-.
1,
2.
3.
4.
428!5 WIRING NOTES:
Wire the
4285
Voice Moduleexactly asshowqusinga direct-connect cordandRJ31Xjack.
If Touch-tines arenotheardwhenpressing keysfollowing phoneaccess t o"thesecuritysystem uia
an
on-premisesphone, @reversing the
pair ofwiresconnected to terminals
3 & 4
on the
4285,
and
the pair of wiresconnected to terminals 21&22 onthecontrol.
If an errorsignal(fastbusy signal)is heardwhentrying to access t he system via the phone,check
for correct l ine seizure wiring,asdescribed i n note4.
Connection to the incoming Telcoline via a RJ31Xjack and direct-connect cord,as shownin this
diagram,is essential, e venif the system is notconnected t o a centralstation.The 4285 will not
functionif this is not done.
The house phone lines (gray and brown wires) must be wired to the Voice Module
terminak, not to the control te " ' . otherwise, an error signal (fast busy signal) will
occur when tryingto aeoesathe systemkm an on-premisesphone.
5. If the telephone system on the premises includes a CallerID unit, comectthe unit direetly to the
"Handset" t erminals (21& 22)onthecontrol. a sshown.
I
IMPORTANT!
I
THE
TELEPHONE LJNEMONITORINGFSATURE
Incoming g
WILL NOT FUNCTION UNLESSTHE PANEL IS
Handset Teko Line ~
00NNEOTED TOA PROPEREARTH GROUND.
TERMINALS ~~ g.
--l
EX1311NG
WIRES
OONNECIED To THE
"HANDSWTERMINAL3
ON00NTROLMU3TBE
MOVED FROMTHERE TO
TERMINAL33
AND 4ON
THE 42S5.
ND
F
INOOMING TELCO
LINE
&g
r=
RJ31x'p
JACK 'N(
1
PREMISES
AN3WERING
MACHINE A ND
1~1
[..~'=-rra i
UNUSED
-E
:N~o:TA OUT(tam 7)
1
,1-TIP
TOCONTROL PANEL
PHONEtNPUT :
OONNECTOR
: 2- RING :
RSD ToAux(+)(teml.51
TERmWS USED FOR ; 3-TIP
WITHFLYING BIAOIC TOAUXGROUND ( -)(term. 4)
KEYPAO 0 0NNEOTION3 f 4- RING }
PHONEOUTPW i
:
GREW TODATA IN(term. S) : 5- GROUND
1
; 6-
}
AUDIOOUT1
1
:7-
(I=OR
FUTURE USE) ~
L--- —-----------. —------J
Figure 16. 4285 Voice Module W- Connectioxw
-52-