Deleting A Serial Number - ADEMCO Vista-20 Installation Instructions Manual

I Learn S/N ?
O= No, l= Yes O II
II
TRANSMIT NOW
II
~ical summarydisplay
m
7.
Ress "1" (Yes).
8.
9.
Activate the transmitter by pressing and
releasing its button, opening and closing a
contact, etc. A "beep" will be heard. After
approximately 8 seconds, activate the
transmitter again – 2 "beeps" will occur,
indicating that the unit has been accepted
into the system.
Now.
A
single long beep indicatesthat that
serial number has been previously accepted
for the system.
If necessary, refer temporarily
to
"58oo
Series Transmitters Table*
in the
WIRELESS EXPANSION section for the
specificmethod used to activate each of the
availabletransmitters.
Ress * to continue.
A summary
of the zone progrsmmin gwillbe
displayed, with a flashing cursor over the
learned loop number %".
Accepted Input (Luop) I$Jumber
Press * to continue to the next zone (if
required*). A prompt for an entry for the
next zone in numerical order will be
displayed.
* If the transmitter has more than one
button, or has contact terminals and a
reed switch (such as the 5816), repeat
the previous procedure for each of the
remaining buttons or contacts (each
button, etc., must be assigned to a
dii%erent z one).
Deleting
a Sarial Number
1.
With
at least one 2-line Alpha keypad (5137AD or 6139) connected to the
system, power up the system temporarily. If the AC transformer was
previously connectedto the control panel, plug in the transformer (to
120VAC outlet)to powerup the system.
2. Enter the progr amming mode by keying the following on the Alpha
keypad
Installer code
(411
2)+ 8+ O+ 0.
m
"'"playd"
3. Ress *83. A
prompt to enter zone number
-73-