ADEMCO Vista-20 Installation Instructions Manual page 46

2
STOP (STP):
A) 1.
B). 1.
2.
If a "SYSTEM OPERATION'-is chosen (e.g., End of Exit
Time), that operation will cause the device to activate as
selectedin "ACTION." The different choices for "ZONE
TYPE" and "SYSTEM OPERATION" are listed in
"Programming g Output Relays & Powerline Carrier devices"
later in this section,and in the Progmmming Form.
PARTITION No. (P). The device's "Start" ZONE
TYPE/SYSTEM OPERATION may be limited to sn occur-
renceon Partition 1, Partition 2, or any partition (A).
The "STOP programming determines when and under
what conditions the device will be de-activated. The
following options are available:
RJE3TORE
ZONE
LIST (ZL). If a "ZONE LIST is used
as the "Stop" event, the device will de-activate when all
the zones in that list restore horn a previous fault, trouble,
or al- condition. This will occur regardless of what is
programmed to "START" the device; therefore, a
"RESTORE ZONE LIST' would normally only be used
when a "ZONE LIST is used to start the device.
ZONE TYPWSYSTEM OPEBATION (ZT).
Instead of
using a "RESTORE ZONE LIST, a specific zone (response)
type or system operation action can be selected to de-
activatethe device.
If a specific "ZONE TYPE" is chosen,any zone of that
responsetype that restoresfiwm a previous alarm, trouble,
or fault conditionwill causethe deviceto de-activate.
If a "SYSTEM OPERATION is chosen,that operation will
causethe device to de-activate. The ~erent choicesfor
"ZONE TYPE" and "SYSTEM OPERATION are listed in
"Programming Relays & Powerline Carrier devices"later
in this section,and in the Programming g Form.
PARTITION No. (P). The device's "Stop" Zone
~e/System
Operation maybe limited to an occurrence on
Partition 1, Partition 2, or any partition.
46-