Intermec EasyCoder 501 Service Manual page 98

12.4 Installation, cont.
Intermec EasyCoder 501 – Service Manual Ed. 7
Standard Cutter, cont.
• Tilt the cutter unit upwards until it locks into place. If the cutter
does not lock properly, the hinges of the cutter unit may need to
be adjusted using a #T10 Torx screwdriver.
• Put back the power cord and switch on power. The cutter will
perform an idle cycle in order to occupy its home position.
• Switch off the power. Tilt down the cutter and route the media
through the cutter unit between the guide plates (see illustra-
tion above). Then tilt up the cutter again and lock it in closed
position. Check that the printhead is lowered and switch on the
power. Now the printer is ready for operation.
Chapter 12 Paper Cutter
Hinge
Hinge
Guide Plates
(insert media between the plates)
97