Installation Of The Top Cover Plate Of The Light Processor Compartment - Barco DP2K SLP Series Service Manual

Removal and installation of the projector covers
Image 22-9
2. Fasten the side cover plate with a screw at the top (reference 1 Image 22-9) and the two screws at the bottom
(reference 2 Image 22-9). Use a 3mm Allen wrench.
CAUTION: Opening the Light Processor compartment by removing the top cover plate or side cover
plate will result in a tamper event. An authorization to clear the security warning on the projector,
after closing off the Light Processor compartment, will be needed!
22.8 Installation of the top cover plate of the Light
Processor compartment
Required tools
Allen wrench 3 mm
How to install the top cover plate from the Light Processor compartment?
1. Install the top cover plate as follows:
1. Approach the projector with the top cover plate tilted as illustrated and insert the two hooks of the top cover
plate into the projector chassis (see detailed illustration Image 22-10).
2. Lower the top cover plate completely.
3. Grip the two knobs (reference 2 Image 22-10) , slide the top cover plate to the rear side of the projector
and ensure that all slots (reference 1 Image 22-10) of the top cover plate are engaged.
278 R5906848 /04 DP2K SLP Series
B
C
C
1
B
A
2