Installation Of The Light Unit Cover - Barco HDF-W30LP User And Installation Manual

22. Removal and installation of the projector covers
Image 22-11
3. Install the side cover of the projector doing the following:
a) Bring the side cover towards its final position (A),
b) then gently push the locking studs of the top corners (B) into their receivers,
c) then gently push the locking studs of the bottom corners (C) into their receivers.
Image 22-12
Mount side cover
4. Secure the side cover by locking the captive screw in the middle at the bottom of the side cover.
Image 22-13
Fixate captive screw

22.7 Installation of the light unit cover

W
ARNING
Necessary tools
7 mm flat screw driver.
How to install the light unit cover
1. Install the light unit cover of the projector as follows:
a) Bring the light unit cover towards its final position (A),
b) then gently push the locking stud at the left top corner (B) into its receiver,
c) then gently push the locking stud at the left bottom corner (C) into its receiver.
284
:
This procedure may only be performed by qualified technical service personnel.
R5906730 HDF WLP SERIES 01/08/2017