Connecting And Disconnecting Power Cables; M To Connect The Ac Power Cable; Figure 3-23 Power Connector For The Ac Power Cable - Sun Microsystems StorEdge S1 Array Installation And Maintenance Manual

Connecting and Disconnecting Power
Cables
The procedures for connecting and disconnecting the power cable(s) vary depending
on whether you have the AC or the DC version of the Sun StorEdge S1 array:
"To Connect the AC Power Cable" on page 62
I
"To Connect the DC Power Cables" on page 64
I
Note – See "Electrical Site Requirements" on page 97 for information on electrical
site requirements.
Disconnecting the AC power cable is a simple matter of removing the cable from the
power source and from the array.
See this procedure for how to disconnect the DC power cable:
"To Disconnect the DC Power Cable from the DC Connector" on page 66
I
To Connect the AC Power Cable
M
Caution – Ensure that the connection of multiple units to the supply circuit does
not overload the supply overcurrent protection or supply wiring. Refer to the array's
nameplate for its electrical ratings when determining the correct branch circuit
rating for your installation.
1. Connect the AC power cable to the AC power connector on the Sun StorEdge S1
array.
FIGURE 3-23
2. Connect the AC power cable to an AC power source.
62 Sun StorEdge S1 Array Installation and Maintenance Manual • April 2003
Power connector
Power Connector for the AC Power Cable