Caution – All power cords should remain plugged into each unit and wall outlets
to prevent damage to the equipment by static electricity from your body.
Caution – Always allow 10 seconds between turning off the power and turning it
back on again. This pause prevents possible damage to power supply components.
!
3.5
Connecting the SCSI Cables
The following procedures explain how to install a tape library in a direct connection
to a system, and how to install a tape library in a daisy chain connection with other
external peripherals and a system.
There are six SCSI ports on the back panel of the tape library. Use these connectors to
enable multiple devices to be connected in a series for daisy chained configurations
(
FIGURE 3-1
FIGURE 3-1
3-4
Sun StorEdge L400 Installation and User's Guide • April 1998
).
Power supply
assembly
Power
switch
Power
connector
SCSI Cable
SCSI Connectors on the Tape Library Rear Panel
SCSI jumper blocks
SCSI terminator