Table of Contents
Advertisement
To Check the Binary SCSI ID LED Display
M
Check the Binary SCSI LED display to confirm that the SCSI IDs are set correctly or
to determine which SCSI IDs are assigned to which disk drives.
1. Remove the front bezel by pressing the latches on both ends and pulling the bezel
away from the array.
FIGURE 5-3
2. Locate the Binary SCSI LEDs (
86
Sun StorEdge S1 Array Installation and Maintenance Manual • April 2003
Checking the Binary SCSI LEDs
FIGURE 5-3
).
Advertisement
Table of Contents
