Hot-Swapping A Scsi Device; To Hot-Swap A Scsi Device - Sun Microsystems StorEdge S1 Array Installation And Maintenance Manual

b. At the ok prompt, use the
on the system.
If you do not use the
ok boot -r
4. Verify that the Sun StorEdge S1 array has successfully connected to the host
system.
Refer to the host system documentation for specific instructions.

Hot-Swapping a SCSI Device

The following procedure uses example of hot-swapping a disk attached to controller
7.
M

To Hot-Swap a SCSI Device

1. Enter the cfgadm(1M) command with the -al option to list all the SCSI devices
on the controller.
The screen example shows the results of listing controller c7.
<sio@qame2-b>: cfgadm -al c7
Ap_Id
c7
c7::dsk/c7t10d0
c7::dsk/c7t11d0
c7::dsk/c7t12d0
c7::dsk/c7t13d0
c7::dsk/c7t14d0
c7::dsk/c7t1d0
c7::dsk/c7t2d0
c7::dsk/c7t3d0
c7::dsk/c7t4d0
c7::dsk/c7t5d0
c7::dsk/c7t6d0
c7::dsk/c7t9d0
<sio@qame2-b>:
command to perform a reconfiguration boot
boot -r
argument, the system does not see the new device.
-r
Type Receptacle
scsi-bus connected
disk connected
disk connected
disk connected
disk connected
disk connected
disk connected
disk connected
disk connected
disk connected
disk connected
disk connected
disk connected
Chapter 3 Installing the Sun StorEdge S1 Array
Occupant Condition
configured unknown
configured unknown
configured unknown
configured unknown
configured unknown
configured unknown
configured unknown
configured unknown
configured unknown
configured unknown
configured unknown
configured unknown
configured unknown
69