Table of Contents
Advertisement
Depending on the type of power switch your device has, one of the following symbols may be used:
On –
Applies AC power to the system.
Off –
Removes AC power from the system.
Standby –
Modifications to Equipment
Do not make mechanical or electrical modifications to the equipment. Sun
Microsystems is not responsible for regulatory compliance of a modified Sun
product.
Placement of a Sun Product
Caution – Do not block or cover the openings of your Sun product. Never place a
Sun product near a radiator or heat register. Failure to follow these guidelines can
cause overheating and affect the reliability of your Sun product.
Noise Level
In compliance with the requirements defined in DIN 45635 Part 1000, the workplace-
dependent noise level of this product is less than 70 db(A).
110
Sun StorEdge S1 Array Installation and Maintenance Manual • April 2003
The On/Standby switch is in the standby position.
Advertisement
Table of Contents
Need help?
Do you have a question about the StorEdge S1 Array and is the answer not in the manual?
Questions and answers