Trunk Group Routing - NEC SL1100 Programming Manual

ISSUE 4.0
Level:
IN
Description
Use Program 14-06 : Trunk Group Routing to set up an outbound routing table for the trunk groups
you assigned in Program 14-05. When a user dial 9, the system routes their calls in the order (priority)
specified. For example, if a user dials 9 and all calls in the first group are busy, the system may route
the call to another group. Trunk Access Map programming (Programs 14-07) may limit this option. The
system contains 25 routing tables for trunk access. Each table has four priority orders for trunk access.
There are 25 available Trunk Group Numbers.
Example for setting:
With less than four trunk groups,
Route Number 1
For the above setting, if all the lines in trunk group 1 are busy, the system searches for an idle line in
trunk group 2.
With more than four trunk groups,
Route Number 1
Route Number 2
For the above setting, if all the lines in the trunk groups 1, 2 and 3 are busy, the system searches for
an idle line in trunk groups 4 and 5.
Input Data
Route Table Number
Priority Order Number
Item Item
No.
01

Trunk Group Routing

Programming Manual
Program 14 : Trunk, Basic Setup
: Order 1 - Trunk Group 1
: Order 2 - Trunk Group 2
: Order 1 - Trunk Group 1
: Order 2 - Trunk Group 2
: Order 3 - Trunk Group 3
: Order 4 - 1002 (Jump To Route Number 2)
: Order 1 - Trunk Group 4
: Order 2 - Trunk Group 5
Input Data
0 = Not Set
001 ~ 025 = Trunk group No.
101 ~ 104 = 100 + Networking System No. (V1.5
Added)
1001 ~ 1025 = 1000 + Route Table No.
14-06 : Trunk Group Routing
001 ~ 025
1 ~ 4
Refer below
SL1100
Default Related
Program
14-01-07
14-05
15-01-02
21-02
2-117
Program
14