Did Intercept Ring Group - NEC SL1100 Programming Manual

SL1100
Level:
IN
Description
For each DID Translation Table, use Program 22-12 : DID Intercept Ring Group to define the first
Program
destination group for DID calls.
22 Depending on the entry in Programs 22-09-02 and 22-11-04, the incoming calls route to the first
destination group by the following:
• Vacant number intercept (vacant number means that no phone is connected, no station unit is
installed, or the extension number is not defined in Program 11-02)
• Busy intercept
• Ring-no-answer intercept
If the destination is 0, the calls are forwarded to the trunk ring group defined in Program 22-11 based
on the table assigned to the DID trunk.
If Programs 22-11-05 and 22-11-06 are set, the priority of transferring is in this order: Program
22-11-05 + Program 22-11-06 + Program 22-12.
For busy and no-answer calls, if the first and third destinations are programmed, but the
second destination is not, the incoming call goes to the third destination after the first
destination. If the first and second destinations are not defined, but the third destination is, the
call goes directly to the third destination.
Input Data
Item
No.
01 Incoming Group Number (V1.5
Changed)
Conditions
None
Feature Cross Reference
• Direct Inward Dialing (DID)
2-270
Program 22 : Incoming Call Setup
Conversion Table Area Number
Day/Night Mode
Item

22-12 : DID Intercept Ring Group

Input Data
0 = No setting
01 ~ 25 = Incoming Ring group
102 = VM
103 = Centralized VM
Program 22 : Incoming Call Setup
ISSUE 4.0
01 ~ 20
1 ~ 8
Default
1