Section 3 How To Enter Programming Mode; Section 4 How To Exit Programming Mode - NEC SL1100 Programming Manual

SL1100
pressed. To learn how to enter the programming mode, refer to
page 1-2.
S 3 HOW TO ENTER PROGRAMMING MODE
ECTION
To enter programming mode :
1. Go to any working display telephone.
In a newly installed system, use extension (port 1).
2. Do not lift the handset.
3. Press Speaker.
4. # * # * .
5. Dial the system password + Hold.
Refer to the following table for the default system passwords. To change the passwords, use
90-02 : Programming Password Setup on page
Password User Name
******
necam
12345678 sltech
0000 ADMIN1
9999 ADMIN2
S 4 HOW TO EXIT PROGRAMMING MODE
ECTION
To-exit the programming mode :
When you are done programming, you must be out of a program option to exit (pressing the Mute key
will exit the program option).
1. Press Mute key to exit the program options, if needed.
2. Press Speaker. If changes were to the system programming, "Saving System Data" is displayed.
1-2
2-530.
Program Mode
Base Service OP1 OP2
Level
1 (MF) Manufacture Level (MF) :
80-02, 80-03, 80-04, 80-05, 80-07, 80-10, 81-04, 81-05, 82-01, 82-04,
82-05, 82-08
2 (IN) Installation (IN) :
All programs in this section not listed for MF, SA, & SB
3 (SA) System Administrator - Level 1 (SA) :
10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16, 10-17, 10-18, 10-23,
10-24, 10-25, 10-28, 10-29, 10-45, 12-02, 12-03, 12-04, 12-08, 15-01,
15-07, 15-09, 15-10, 15-11, 20-16, 20-34, 21-07, 21-14, 22-04, 22-11,
22-17, 25-08, 30-03, 30-04, 32-02, 45-02, 84-22, 90-03, 90-04, 90-06,
90-07, 90-19, 90-57, 90-58, 90-59, 90-65
4 (SB) System Administrator - Level 2 (SB) :
13-04, 13-05, 13-06, 13-11, 15-14, 21-20
Program Mode
Base Service OP1 OP2
How to Enter Programming Mode on
Programs at this Level
ISSUE 4.0
Introduction