Connecting A Remote Passive Panel; Connecting For User Port Control; Connecting To The Standard Serial Port; Connecting For Serial (Host) Port Control - Advanced Energy Pinnacle User Manual

Pinnacle™ 20 kW

Connecting a Remote Passive Panel

Connections for a remote passive front panel are made through the female, 15-pin,
subminiature-D connector labeled REMOTE PASSIVE PANEL on the rear panel.
The rear of the remote passive panel features a male, 15-pin, subminiature-D
connector. Use the cable provided with the remote passive panel to connect the panel
to your Pinnacle unit.

Connecting for User Port Control

Please reference the "I/O Communication and Control" chapter for instructions on
connecting your analog/digital interface.
Note: To reduce EMI interference, we recommend using shielded cable to connect to
the User port.

Connecting to the Standard Serial Port

This interface lets you use most parameters of the AE Bus communications protocol
during serial communications with a host computer. Please reference the "I/O
Communication and Control" chapter for details on making this connection.

Connecting for Serial (Host) Port Control

Please reference the "I/O Communication and Control" chapter for instructions on
connecting your serial communications (Host) port.
Note: Any time you remove one Host card and replace it with another, you must
restore all system defaults. Restoring defaults will reset User port limits and the
front panel display; additionally, restoring defaults will ensure the Pinnacle unit
recognizes the new Host card (or lack of Host card).
Note: To reduce EMI interference, we recommend using shielded cable to connect to
the serial port.

Contactor Interlock

CONNECTOR

The CONTACTOR INTERLOCK port, located on the rear panel, is a 9-pin, male,
subminiature-D connector (see Figure 5-3 on page 5-8). Before turning on output,
ensure that the interlock loop is closed.
On the 400 V Pinnacle supply, Pins 1 and 2 on this port are feedback connections from
a set of (normally open) auxiliary connectors on the main contactor. To enable the
Pinnacle supply's main contactor, short together pins 3 and 4 on the CONTACTOR
5702156-E Installation 5-7