Soft Keys; Modify Knob; Control Panel Controls - Advanced Energy Pinnacle User Manual

®
Advanced Energy
4 S: Setpoint timer enabled
4 V: Process voltage monitor enabled
4 H: Hard arc counting enabled
4 Q/T/R: Recipe queue, TCC mode, or ramp enabled
4 C/P: Custom or predefined arc handling enabled
• Warning field
4 Warning field: flashes "EOTL" when end of target life or "ARCLIM" when the
arc limit is reached.
Note: ARCLIM is only active when the Hard Arc Counting feature is enabled.
• Clock ID: what the supply is doing
4 RMP = output is on and ramping
4 RUN = output is on and the clock shows the elapsed time
4 TCC = output is off and the TCC mode timer is active
4 OFF = output is off and the clock shows the last run time
• Clock

Soft Keys

Use the soft keys to select whichever menu functions are shown immediately above
them on the two-line display. "" on page 4-47 explains how to perform these
operations from the Pinnacle control panel.
Note: If you're at the top level, press the MENU soft key to make the menus appear.

Modify Knob

Use the MODIFY knob with the soft keys to change selections and modify values that
appear on the two-line display.

CONTROL PANEL CONTROLS

Use the MODIFY knob and the five unlabeled soft keys that are directly below the
display to select parameters and modify values. To changes parameters using the
menu, the Pinnacle unit must be in local control mode (the LOCAL LED will be lit).
Note: When the Pinnacle unit is in User or serial (Host) mode, you can view all the
menu items, but you cannot modify any of the items or lock the unit. If you
switch the Pinnacle unit to User mode while you are viewing an item in the
menu, you are returned to the output display screen immediately.
4-20 I/O Communication and Control 5702156-E