Switch Settings For The Possible Network Addresses - Advanced Energy Pinnacle User Manual

20 kw (325-650 vdc) devicenet, ae bus, mdxl user, terminal block output

Table of Contents

Pinnacle™ 20 kW

The mode of differential communication (that is, RS-485 or RS-422) is selected via

the jumper labeled as such. Place the jumper across pins 1 and 2 for RS-485 (labeled

485). Place the jumper across pins 2 and 3 for RS-422 (labeled 422).

If you have selected RS-422 or RS-485, you also have to set two terminator jumpers.

If have selected RS-422 or if your Pinnacle unit is the last device on an RS-485 multi-

drop chain, place the jumpers across pins 1 and 2 (labeled Term.). If you have

selected RS-485 and your Pinnacle unit is not the last device on a multi-drop chain,

place the jumpers across pins 2 and 3 for no termination.

SWITCH SETTINGS FOR THE POSSIBLE NETWORK ADDRESSES

Use the DIP switch (see Figure 4-12 on page 4-50 and Figure 4-13 on page 4-50) to

set the unit's network address. Table 4-14 offers examples of how to set the switches

for possible address settings.

Note: When the unit is a dual output power supply, side B's address is side A's address

plus 15 decimal; thus, the highest usable address for side A is 16.

Table 4-14. Address Settings

Address

5702156-E

Don't assign this address to a unit; it is the network broadcast

address--all Pinnacle units receive a message sent to this address by

the host, but will not reply.

down

I/O Communication and Control

down

4-53

Table of Contents

Show Quick Links

Table of Contents